INSTALLATION KIT FOR THE ARGYLE LOCO
NSWGR. "C-38" LIVE STEAM LOCO. Feb 1st 2017
Remote Control Systems (RCS)
is pleased to announce our new 2.4 GHz DSM2 EVO-STEAM pocket sized hand piece for Live Steam locos.
RCS TX's are marked CE and are FCC compliant but not tested or approved.
RCS TX's are marked CE and are FCC compliant but not tested or approved.
PHOTO COURTESY OF ARGYLE LOCOMOTIVE WORKS.
VISIT ARGYLE LOCOMOTIVE WORKS.
COMPLETE R/C KIT FROM ONLY A$199 (plus postage)
Kit comprises;
1 x basic 3 channel 2.4 Ghz DSM2 EVO-STEAM & Rx102-1(AB)LR RX,
1 x Hi-Tec HS65mg servo,
1 x 4 cell AA battery holder,
1 x ON-OFF switch w/charge lead.
Please note. This kit controls just the steam regulator. Direction is set by the screw reverser in the loco. For R/C control of the reversing, extra parts will be needed. Contact RCS for advice.
Please note we can no longer supply pre-made 4.8 volt NiMh packs or the charger used to charge them. Other chargers are available.
ALL PARTS ARE AVAILABLE SEPARATELY. Cost = A$ 203 plus postage.
| C38 KIT STEAM | ||
 |
| Model | Price | Image | Description |
|---|---|---|---|
| 2.4 GHz 3-7 CHANNEL RADIOS (Servos not inlcuded). | |||
|
RCS EVO-STEAM 3 Ch 2.4 GHz DSM2 TX. |
|||
| EVOLUTION STEAM "A" |
$99 |
 |
DSM2 3 x CH R/C TX For controlling Live Steam locos. Same as TX-1 in a smaller case. pdf instructions |
| TX-3 |
$119 |  |
ENTRY LEVEL "PLUS" DSM2 R/C Designed for both entry level Live Steam and experienced operators. Johnson Bar, Regulator & 3 x Snap action servo functions. pdf instructions |
| TX-5 |
$119 |  |
5 channel DSM2 R/C Designed for Live Steam locos that require controlling the Johnson Bar, Regulator, Drain Cocks, Blowers & gas control etc. Proper fully proportional Whistle function. 1 x Snap action servo for uncoupling. pdf instructions |
| TX-7 |
$159 |  |
DSM2 R/C for 2 x servo Live Steam locos. Use with any DSM2 compatible RX including the DSM2-EM(AB) 5 channel RX below. 1 x Snap action Whistle function. 4 x 1/2 servo movement functions. pdf instructions |
| AUTOMATIC BINDING DSM2 RX's. 5 Channel RX that is programmable for Live Steam servo direction & end points. No Failsafe. Turn off TX to cruise at last servo setting. Built in Forward and Reverse LED lighting outputs. |
|||
| Rx102-1(AB)LR |
$39 (L) |  |
Long Range 5 channel RX. RX can be in metal loco body with the shielded antenna tip exposed for extra range. pdf instructions |
| PRE-WIRED PLUG IN LEDS FOR DIRECTIONAL CONTANT BRIGHTNESS LIGHTING. ONLY TO BE USED WITH ABOVE RX's. Installation may require some cutting and soldering. |
|||
| LED-3mm-G |
$ 6 (L) |  |
Standard 3 mm green LED on a plug in cable. Use as refernce light when programming etc. |
| LED-3mm-WW |
$10 (L) | |
Warm White 3 mm High Intensity LED on a plug in cable. Follows Front & Rear direction. Use for reference when programing. |
| LED-5mm-WW |
$10 (L) | |
Warm White 5 mm High Intensity LED on a plug in cable. Follows Front & Rear direction. Use for reference when programing. |
| Model | Price | Image | Description |
|---|---|---|---|
| ON - OFF SWITCH & BATTERY HOLDER. Plug and socket connections. |
|||
|
HT-7215
|
$10 (L) |
 |
Hi-Channel ON-OFF switch with standard 3 position 2 wire connections.
Includes an externally accessible charger lead. |
|
4-AA-FLO
|
$ 6 (L) |  |
Holds 4 x AA size batteries in a FLat Open format. Flat holder for under roof etc.
With standard RX battery plug. |
|
SL-6-Ex
|
$3 (L) |  |
6" extension servo lead. Used where RX is separated from the servos. EG Tender locos.
Simplifies uncoupling tender from loco. |
| SERVO. | |||
| HS-65MG |
$49 |
 |
Hi-Tec® mini servo with metal gears for long life. Servo recommended by Accucraft for the C38. |
| Model | Price | Image | Description |
|---|---|---|---|
| BATTERIES | |||
|
SB2423
|
$ 4 |
 |
LOW COST QUALITY
9 volt PP3 Alkaline batteries for TX handpieces. |
|
S4955B
|
$ 4 |  |
LOW COST QUALITY
1.5 volt AA Alkaline batteries pack of 4. |
|
LSD-AA
|
$27 (L) |  |
Pack of 4 x fully charged AAA ENELOOP
2,000 mah LSD hybrid batteries. Ideal if you plan on using AA size battery holders. |