RCS # BTL-6r

Please note.  The RX's shown below plugged in are for illustration purposes only.
They are sold separately & not supplied with the RCS # ECL-6r.
 
2 x Part ESC available for four different brands of R/C.
 
   SPEKTRUM & PLANET are group "A" RADIOS.  They MUST use the "BTLvA2" Program.

Vertically mounting an RX can be inconvenient.
They can be set up for remote connection with the separate purchase of the # DEC-ADPT.
 
 E-SKY & HOBBY KING are group "B" RADIOS.  They MUST use the "BTLvB2" Program.

 
As there is a bridge rectifier on the ESC we advise using a couple of more volts than normal to compensate.
 
BATTERY VOLTAGE:
  All battery packs state a NOMINAL voltage on the pack. 
When freshly charged the actual voltage can exceed the NOMINALvoltage.
eg. An 18 volt Ni-Cd pack can read 24 volts when fully charged.
  RCS  takes into account the excess voltage when batteries are freshly charged when listing what is the maximum voltage you can use.
Likewise the NOMINAL voltage also takes into account the likely voltage drop when discharging.
It is the NOMINALvoltage on the battery pack that is the maximum & minimum voltage you can use.

*We recommend using a 5 volt fan when using the the RCS BTL-6r at higher voltages.

Ideally "BINDING" the TX & RX together is done before installing the RX into the # DEC-U decoder part.
This can be done with any regular R/C RX battery pack and following the R/C maker instructions.
If this is inconvenient we offer, at extra cost, the # EX-LD which will enable "BINDING" away from the # DEC-U.



It is used like this:



The # EX-LD cable can go in any socket of the RX and # DEC-U. 
They must be the same way around.  Orange wire to the middle.