# DEC-ADAPT

 
This is a small pcb with servo leads attached.  It has two purposes:
1. Required when Hobby King & E-SKY RX's are to be used with the # DEC-U.

2.  Will enable remote placement of the RX.
This is very useful if the RX would normally have to be mounted at Right Angles to the # DEC-U pcb. Like this:


Take the # DEC-ADPT in one hand & the # DEC-U in the other:

 
 
Then line up the pins 1 - 6 on the small pcb with the sockets on the # DEC-U:

 
 
Push the small pcb gently into the socket:

 
The other end of the cables will look like this:

  When used as an extension cable only, the three way cable goes to servo outlet # 1 with the Orange wire towards the face of the RX.
The other single wire cables go sequentially in order.
 

PRINT OUT A SET OF PDF INSTRUCTIONS.